good morning first you need to have very very carefully if you want to pick up the headlight from dash because we need to take carefully with the other controls, . well next, take a a chance to move screw from pannel some times need a special tools, and take out about four screwdriver, but only if you can do it,then take the pannel out and if you can with your hand take out the switch. take care with the arnnes or plugs. and not cut any wire. so if you have a doubt ican here with some drawing about that thanks a lot i attended juan ramon
first of all this disconected the battery of the car, and then do it.
is the same of this chek it all i hoppe you helped to your question.
Both of my head lights suddenly cut out and I figured it was the dashboard switch. Got a replacement from Sunset Porsche for about $80.Thought I'd take a few snaps detailing the process for the rest of you gear heads!1- Disconnect battery. Then take out two #20 tork screws on the lateral aspect of the left AC vent:
2- remove the light switch **** by pushing in the lock under the **** with a small screw driver and pulling
3- remove 3rd tork screw in medial aspect, behind ****:
4- pull AC vent straight back- surprisingly snug- requires a firm pull
5- remove nut around light switch
6- disconnect electrical connections
7- remove bezel around **** and switch
8- twist switch to remove
9- when replacing make sure groove in switch lines up with grove in bezel or else bezel will not seat flush. 10- reconnect battery and off and work in those
My porsche Boxster 2008 dash do not look like tehe photos you sent to me,so I can't id the parts.
ok i.sorry, give just a moment i come back again.
if you want to givme moere information abaout you car. model or if you try to put a nother switch from the dash. or if you can move this switch no another place together with the light. forgivme ii i couldnt undertand before.so i am to helpyou and i want you attend you better.
so i wait your addicional information ok
see you later
The light switch does not have a lock (instruction # XXXXX).I pull out the switch knob hard and came out,but is a plastic piece and doesn't have any tork screw behind (instrution # XXXXX) and the AC vent is not together in my model (Boxster 2008). Also there's not any nut around light switch like you say in instruction # XXXXX I still unknowing how to take out the light switch without damaging my car trim.